The Solution Has Been Found

[LustInBlack]

MT136b

[justsomeone]

Axel,

You are sounding a lot like Cristo4-99.

Instead of clues, why not just state why you think you know how it works.


What was the purpose of this thread?

[axel]

I know. Maybe I shouldn't have started this thread. I want everybody to stop what they're working on and wasting time. Everything I've seen and read on this board, including all my stuff is all wrong. Go back and pick any thread or any post. It's all wrong. If that's a detail, then it's one that covers a lot of them.

[LustInBlack]

That's quite an easy statement to make ;)

[Unbalanced]

Axle,

Congratulation.

Just, if I dribbled out a detail here an there it would just look like I'm playing with you guys.
The solution has been refound.

By all means Play with us... surely you can disclose some manner of detail without disclosing the actual mech.. Something like,

How you definitively came to this conclusion. Have you actually created a devise that turns without stopping?

I sure hope so.. It would be wonderful.. Curtis

[Art]

Hi Tarsier ,

I use the total number of revolutions that the balanced wheel makes when driven by a 470g weight dropping about 600 mm as a benchmark in order to compare the efficiency of a device or process .

The wheel is a 1 meter disc of 4.5 mm opaque acrylic sheet . On the axle and roller bearings it weighs 6.5 Kg . Unloaded it revolves 120 revolutions before stopping completely . As soon as I put anything that does anything on it and rebalance it , this drops to about 60 revolutions.

To answer your question about speed : Typically it takes about 4 minutes to complete 60 revolutions , so it averages about 15 rpm. but starts at 60 rpm .

Testing this way is really making me aware that friction and Newtons 3rd Law are intimate friends .

It seems to indicate (and in retrospect it seems perfectly obvious ) that ALL friction is directly related to ANY momentum changes occurring in the associated masses.
Friction is a release of energy from the forces involved in the 180 degree equal and opposite reaction of two interacting masses .

It seems to be all about force direction . If you could change the direction of force from the reaction just a few degrees away from that 180 degree “reaction angle� of Newton you should end up with an ’inertial’ turbine : )

[Tarsier79]

Thanks Art.... I was half asleep, I didn't realise I wrote your name instead of Axel.

[rounder]

Hello Axel , just from reading the topic of this thread. One would believe that a solution has been found.

[/b]If so ,have you had any luck with the build yet, is there any updates to this.

[Wubbly]

.
http://www.besslerwheel.com/forum/viewt ... highlight=

[nicbordeaux]

You'd better hurry up, apparantly the world is ending in December...

[AB Hammer]

Nick

You know when free energy from gravity becomes a reality. It can be the end of the world as we know it, and we can smile in the new world. ;)

[Ken]

Alan,

I modified the low drum.

When you see it you are gonna smack yourself in the face. It is so simple.

I think you already had a design very close. You can build it in a day or 2.

Message me.

[Tarsier79]

Gday Axel.

How is your build going?

Ever check your PMs?

[axel]

Will tell this much, since we as a group are fast approaching the 300th anniversary.
I HAVE, by accident, awhile back, discovered what the prime mover was in JB's wheels.
The way I have everything set up, weights can fall without stalling the wheel.
Yet, it is not their impact on the stop which is important.

[Grimer]

"it is not their impact on the stop which is important"

Agreed.